Replacement of the battery in Hoverboard

The rapid drop in battery power or its complete failure leads to a marked decrease in the dynamic characteristics of the hoverboard and even to the total inability to use it.

This procedure is quite expensive due to the high cost of components. Realizing this fact, preliminary diagnostics of the battery itself, systems and gyroboard elements are carried out. This allows you to identify the causes of premature battery wear and the need to replace it. This approach allows minimizing the costs of the owner of the device and avoiding the failure of the power supply in the future.

Hoverboard power supply: technical specifications and operating features

Hoverboard belongs to the category of individual transport, which should be used on roads with a hard surface. In motion it is driven by an electric motor the wheel is located directly on its shaft. This scheme greatly simplifies the mechanical part of the device. The power source is Li-on battery, the parameters of which in most models are:

  • The capacity is not less than 4500 mAh or 160Wh.
  • The rated voltage is 36 V.
  • The temperature range of use is from -40 ° C to + 60 ° C.
  • Time to critical reduction in the level of charge in the standby mode is more than 100 hours.

The modern hoverboard speed, which reaches 10 km / h, can travel up to 25 km. The power is turned off when the battery charge drops below 10%, the control is carried out by the electronic module. The most common causes of failure of batteries:

  • Violating the charging rules or using non-standard devices.
  • Failure of the charge controller.
  • Battery overload due to abnormal operation of the control board or motors.

Determining the need to replace the battery hoverboard

During the diagnostics all basic elements of the construction and parameters of the standard device are checked. Next, the device is disassembled and the diagnostics of its mechanisms and systems, which affect the functioning of the battery, are performed.

Selection and installation of a new battery

During the replacement, the battery connection is made exclusively using standard circuits. The complexity of the design of the device and the need for accurate diagnosis make the repair of a hoverboard of any brand by their own hands a matter of no prospects. Danger of explosion of battery.