Hoverboard - the red light is on and it does not work
It happens that after a short use of the Hoverboard or even because of something, this problem arises. In fact, there are a lot of reasons for this mistake. In this article, we will discuss the basic and what to do in such cases.
Hoverboard: the red light is on and it does not work, what should I do?
Content
- Main reasons
- How to solve the balancing problem?
- Conclusion
Main reasons
It must be remembered that if the gyro camera is red, then it indicates any error or malfunction. Many modern models have a number of sensors inside, which in turn, based on the problem, point to a particular error. The light bulb can just burn or blink.
And now you see the gyro and the red light on it flashes, then the limit of the angle of inclination of the surface is most likely exceeded. It happens when you move out or try to get too steep. The average allowable angle of inclination is usually 15 degrees, if the angle is greater, the Hoverboard not travel.
If the gyro wiper still blinks red even on a flat surface, then the probability is that the gyroscopes are lost. On two parts of the platform gyroscopic sensors are located, which read information about the position of the board relative to the earth's surface. It is clear that they should be configured the same way. But often happens, when riding on a bad road and strong vibration or strong bumps, gyroscopes can get lost.
Another rather common problem is the disconnection of any wire inside. With this, it's all clear, this technique and wires can retreat or oxidize as a result of the work. But here you must remember that in no case do not disassemble or remove the gyro cover, if it is still under warranty, otherwise you will break the warranty seals and the gyro pacemaker will immediately exit it.
And since you do not know exactly what is the reason, you can not only do not fix it, so you also have to repair it for your money, although the marriage could have been from the seller. If gyroskouter is not under warranty, but you live in a remote taiga and you do not have a nearby service center repairing gyro pacemakers. Then you need to turn off the gyro-wiper, remove the lid and check all the wires for continuity and connection.
How to solve the balancing problem?
And so you have a red light on the Hoverboard and it does not work, or it's going crooked, what should I do? To do this, you need to configure the sensors relative to each other or as otherwise called, adjust the balance or calibration of the gyroboard. Next, you need to put gyro-footer on a flat surface, preferably on a flat floor, it is not recommended to do this on a table or other surfaces, since there may be a slight slope.
After that the Hoverboard is placed in a level position, so that both parts are parallel to the floor, you can slightly hold it with one hand, so you will feel which of the halves is tilted and fix it. It should be remembered that in this position, the motion sensor and the battery charge sensor should look straight at each other.
Then press the power button and hold it for 6-11 seconds. After this, the light will blink, release the power button. Wait 11-16 seconds or until the light stops blinking and turn off the gyro, then try turning it on and trying to ride it.
Conclusion
If the problem is not solved, then most likely the problem is in the iron of the gyroscope itself and you will have to carry it to the service center. Once again, remember, do not try to repair giroscuiter if it is in your warranty, take it to the store where you bought it. And try not to buy very cheap models and Hoverboard from your hands.