Solowheel PDF User Manual
Solowheel Manual
Hard / Soft mode (if dual mode Soloware): the Soft mode accompanies the rocking of the body, and the wheel bends and bends with you; Hard mode is more static and more horizontal compared to the ground, regardless of the inclination of your body.
Turn off the Solowheel
- Lay the Solowheel off [S300: to the right (the light down) / Xtreme: to the left]
- Turn on the Solowheel, wait 1 second
- Raise the right Solowheel
- Turn off the Solowheel
- Light the Solowheel. When the Solowheel starts in Hard mode, the S300's LED is red for 1 second before going green and the Xtreme's top rear LED is red for 1 second then orange.
- Horizontal Calibration (according to Soloware): Use only if the Solowheel is decalibrated due to mishandling.
Turn off the Solowheel
- Lay the Solowheel off [S300: to the left (the light up) / Xtreme: to the right]
- Turn on the Solowheel, the light will come on and flash
- Lay the Solowheel against the other side
- Raise the right Solowheel, the indicator flashes red / green for 10 seconds, during which time
- Level the Solowheel with a spirit level positioned on a horizontal footrest
- The position is saved after 10 seconds, when the LED is solid green on S300 or orange fixed on Xtreme
- Turn off and then turn on the Solowheel
- Check the horizontal with a spirit level, if the level is bad, start again at step 1.
Battery indicator:
You will find a diode that lights up in green when the battery is charged between 100% and 25%, goes orange between 25% and 5% (autonomy then estimated at 2.5 km) and turns red under 5 %.